Beef

Reverse-Seared Tomahawk

A thick tomahawk cooked low and slow first, then seared over roaring coals. The reverse sear gives you an even pink from edge to edge and a dark, crackling crust. The kamado does both in one cook.

Time
2 h
Temperature
110°C / 300°C
Serves
4
Tomahawk steaks seared over open flames on The Bastard

Method

  1. Prep the steaks.

    Take the tomahawks out of the fridge an hour before cooking. Pat them dry and season generously on all sides with coarse sea salt.

  2. Set up for indirect.

    Put the Plate Setter in and bring The Bastard up to 110°C. Add a chunk of oak to the coals for a light smoke if you like.

  3. Cook low.

    Lay the tomahawks on the grid, insert the core thermometer in the thickest part away from the bone and close the lid. Cook until the core reaches 48°C, about 60 to 75 minutes depending on thickness.

  4. Rest briefly and fire up.

    Take the steaks off and cover them loosely. Remove the Plate Setter with heat-resistant gloves, open the bottom vent and the top fully and let the kamado climb to 300°C or more.

  5. Sear hard.

    Put the tomahawks back directly over the coals. Sear for 1 to 2 minutes per side with the lid open, turning a few times, until the crust is dark and the core is at 54°C for medium rare. Watch for flare-ups from the fat.

  6. Rest.

    Rest the steaks for 5 minutes on a board. Brush with the melted butter, garlic and rosemary.

  7. Slice and serve.

    Cut the meat off the bone and slice it against the grain into thick strips. Finish with flaky sea salt and black pepper.

Bastard tip: open the vents slowly when you go from 110°C to sear temperature. If you open the lid on a hot kamado too fast, the sudden rush of air can flash. Burp it: lift the lid a few centimetres first, then open fully.